Wednesday, August 12, 2009

"Carbonado" or Black Diamond


Carbonado, commonly known as the 'Black Diamond,' is a natural polycrystalline diamond found in alluvial deposits in the Central African Republic and Brazil. Its natural colour is black or dark grey, and it is more porous than other diamonds.


Unusual properties:
The characteristics of carbonado noted in this section are based mainly on the summary of Heaney et al. (2005), unless otherwise noted.

Carbonado diamonds are typically pea-sized or larger porous aggregates of many tiny black crystals. The most characteristic carbonados have been found only in the Central African Republic and in Brazil, in neither place associated with kimberlite, the source of typical gem diamonds. Lead isotope analyses have been interpreted as documenting crystallization of carbonados about 3 billion years ago. The carbonados are found in younger sedimentary rocks.

Mineral grains included within diamonds have been studied extensively for clues to diamond origin. Some typical diamonds contain inclusions of common mantle minerals such as pyrope and forsterite, but such mantle minerals have not been observed in carbonado. In contrast, some carbonados do contain inclusions of minerals characteristic of the Earth’s crust: these inclusions do not necessarily establish formation of the diamonds in the crust, however, because these obvious crustal inclusions occur in the pores that are common in carbonados. These inclusions within pores may have been introduced after carbonado formation. Inclusions of other minerals, rare or nearly absent in the Earth’s crust, are found at least partly incorporated in diamond, not just in pores: among such other minerals are those with compositions of Si, SiC, and Fe-Ni. No distinctive high-pressure minerals, including the hexagonal carbon polymorph, lonsdaleite, have been found as inclusions in carbonados, although such inclusions might be expected if carbonados formed by meteorite impact.

Isotope studies have yielded further clues to carbonado genesis. The carbon isotope value is very low (little carbon-13 compared to carbon-12, relative to typical diamonds).

Carbonado exhibits strong luminescence (photoluminescence and cathodoluminescence) induced by nitrogen and by vacancies existing in the crystal lattice. Luminescence halos are present around radioactive inclusions, and it is suggested that the radiation damage occurred after formation of the carbonados, an observation perhaps pertinent to the radiation hypothesis listed below.

CARAT


Carat refers to the weight of your stone, which is often used to determine general size. Carat weight is determined by the above mentioned scale.


Why Are Diamonds So Popular?

Through the publicity and promotion given to diamonds largely by the De Beers Company, and through the Diamond Promotion Service, diamonds have become the most desired gemstone.
Thanks to large scale mining, and the development of efficient cutting methods and equipment, diamonds have now become a consumer luxury affordable to the masses.
Mass production jewellery manufacturing techniques have also helped to bring diamond rings and other diamond jewellery into very affordable, even commodity, price ranges

What Makes Diamond An Ideal Gemstone?

Diamond possesses many qualities which make it an ideal gemstone.




It is extremely hard, and also very tough and hard-wearing, and this also helps it to take a very high polish. Some hard articles are brittle which detracts from their durability. Only cubic boron nitride (borazon) is harder.
In its pure form it is colourless, has a high refractive index, so has a very high lustre.
It possesses high dispersion, meaning that different light wavelengths are diffracted differently, giving a strong scintillating play of prismatic colours.

4 C's of evaluating Diamonds









The four Cs provide a standard for evaluating Diamonds.




Color: Diamonds can cover the entire spectrum of colors. The majority range from a perceptible yellow or brownish tint up to the very rare diamonds described as colorless. Colorless diamonds are the most desirable since they allow the most refraction of light (sparkle). Off white diamonds absorb light, inhibiting brilliance. You can best observe diamond color by placing the stone table side up on a flat white surface or grading trough, and examining it from different angles. Next, place it table-side down with the culet facing you, and examine it through the pavilion facets


Cut: Cut has the greatest influence on the diamonds fire and brilliance. A round, brilliant-cut diamond has 28 facets. When well proportioned, this shape best shows the stones brilliance because it allows the most light to be refracted back to the eye of the observer. Stones that appear lifeless or stones that appear dark in the center are poorly cut. When the angle relationship between the crown and pavilion facets is correct, rays of light entering the diamond strike the rear facets at an angle greater than the critical angle. (24.5 degrees for diamond), and reflect back to the eye of the observer. If the stone is cut too deeply the light strikes the rear facets at an angle less than the critical angle and the light is lost through the sides of the diamond. If the diamond is cut too shallow, the light passes through the diamond without being reflected back. (no sparkle).


Clarity: Most diamonds contain minute traces of non-crystallized carbon in internal stress factors. Called inclusions, most of these are not apparent to the naked eye but can be seen under magnification. Perfect clarity means that no inclusions are discernible when the diamond is examined under a 10x magnification lens. Inclusions greatly effect the beauty and value of a diamond because they absorb the light rather than allowing it to be reflected back through the front side of the stone. How much they reduce the value of a diamond depends on their size, number and position throughout the stone. An inclusion in the center of the diamond beneath the table is more visible than one near the edge. The inclusion may also be mirrored many times by adjoining facets.



Carat Weight: The term "CARAT" comes from the ancient practice of weighing diamonds against the seeds of a carob tree. The system was eventually standardized, and one carat was fixed at 0.2 grams. One carat is divided into 100 points, so a quarter-carat diamond is 25 points or 0.25 carat. Although carat is a unite of weight, not size, the carat weight of a diamond has come to refer to particular sizes. If properly cut, diamonds of the same weight should be about the same size. These sizes do not apply to other gems, however, because their specific gravity's differ from a diamond.

Round Diamonds in Men diamond ring for Rounds and Princess


Round Diamonds in Men diamond ring for Rounds and Princess



Setting Price: US$850
Metal: Metal Shown: 18K White Gold-Rhodium Dipped (change metal choice at jewel details page)
Max Width: 8.6mm
Min Width: 3.5mm
Gold Weight: 7.5gr
Delivery Time: 8 Days to the USA.
Details: Settings is suitable for Round cut diamonds 0.38 to 0.75 carats.
Can be High Polished or Burnished finish.

Princess Diamonds in Heavy Men diamond ring


Princess Diamonds in Heavy Men diamond ring


Setting Price: US$1,290
Metal: Metal Shown: 18K White Gold-Rhodium Dipped (change metal choice at jewel details page)
Max Width: 12mm
Min Width: 8mm
Gold Weight: 18gr
Delivery Time: 8 Days to the USA.
Details: For round diamonds 5mm to 8mm (0.5 to 1.85 carats